Reset Button On Maytag French Door

Reset the filter status light by pressing and holding the filter reset button.

Reset button on maytag french door.

On the control on the door it should be the buttons on each end. Any suggestions on how to fix permanently. Maytag french door refrigerator by. Soon after it too started freezing.

Most don t automatically reset. Whirlpool gold french door display panel lights go out no reset button procedures work however if i unplug the wiring harness at the top hinge of door and reconnect the display comes back on and works fine for several hours even a couple of days. They told me i needed another ice maker so i purchased another one. Anonymous i purchased this maytag french door refrig.

They told me i need a new water valve so i replaced the water valve. Then it will do it again. Verify that the ice maker is turned on. These are the freezer temp and fridge temp buttons.

If the ice maker s water supply is not connected to water supply line turn the ice maker off. Unfortunately this is a very common way for this french door unit to fail. Press them at the same time and hold for at least three seconds. The status light will turn off when the system is reset.

If the appliance has a reset button it should just need to be held in for 30 seconds to correct the fridge. Press the temperature down button once more and the reset code will be displayed. Wait three seconds release the button and you should see pe on the display which indicates the control panel is in programming mode. Press the door alarm and temperature down buttons simultaneously and release the door alarm button.

Some refrigerators including maytag and amana need to have the lock button and the reset or auto buttons held at the same time to reset the fridge. Resetting the water filter status light for maytag refrigerators. If the ice maker is on but disconnected to water supply line the following could happen. You can try to unplug the refrigerator for 5 minutes and see if the electronics will reset but if not it means that your main control board on the back of your refrigerator has failed.